Rocket Science

I managed to get some work done on my L3 rocket today. The centering rings' ODs were about 1/32" too large. I used a dremel and a...

I plugged it in and measured voltages across some of the components using a super cheap volt meter. With black tape on the photoresistor (LE...

This process has been such a pain in the ass, so hopefully this will save you some stress. The HP Split has two hard drives. A small SSD (...

I haven't done much fabrication. I installed the AeroPack 98mm retainer on the rear centering ring. This was kind of a pain in the ass. ...

I got around to sanding the fins. I started by marking a line for the ~10 degree bevel on both sides and a line down the center of the edges...

The Mark1's CAD is on my public google drive now. Sorry for the odd part names; just start with the full assembly and figure out what I...

I screwed the thrusters to the hover racer. They were a bit too high to produce thrust, so I had to bend their mounts down until they stuck ...