Rocket Science

I installed the new venturi meter and re-ran the previous tests. As a reminder, the goal is to determine the flow rate and pressure drop in ...

I set up a long print for two of the Phi fan adapters. I checked on it every now and then, and it seemed fine, but I didn't look close e...

After applying the slicer software band-aids determined in the last post, the print quality is now adequate at normal speeds. XYZ calibrat...

Well, the hot end repairs definitely helped, but not enough. So this under extrusion/blob thing is not all a thermal problem. Update/summe...

First, some successful prints. These were printed at 20 mm/s due to the aforementioned thermal problems. Despite some initial under extrusio...

I completed the test setup. I'll let the pictures do most of the talking: Drying after washing after sanding ports flush to ins...

I hinted at another big project I was undertaking in my first homelab post . I purchased 140 used Xeon Phi cards recently, from the same so...